Skip to main content

Updating Wi-Fi Settings Using the Lunar App

O
Written by Ollie Wells

Updating Wi-Fi Settings Using the Lunar App

lunarenergy.com

Note: Your Lunar System is only compatible with 2.4 GHz Wi-Fi networks.

Check Your System's Network Connection

Go to the "Settings" page in your app and tap "Network connection" under "Your home overview." Here you can see the last updated data for each connection type, including the device's MAC address, IP address, and last time the connection status was reported.

Setting Up a Wi-Fi Connection

If you don't currently have a Wi-Fi connection set up, you can easily configure it through the app.

  1. Go to your Lunar System, open the app, and head to Settings.

  2. Tap Network connection, then choose Configure Wi-Fi.

  3. In the pop-up, note your Lunar System's Wi-Fi ID (something like LUNAR_SIE234700016) — you may need this later.

  4. Ensure you're standing close to your Lunar System before tapping OK. Your device will now try to connect to your system.

  5. Your device may automatically connect to your Lunar System's Wi-Fi network, or require you to review the network request. Check that the network name matches the Lunar System Wi-Fi ID from Step 3 (starts with Lunar_SIE) and tap Connect.

  6. If the connection fails, you'll be asked to scan the inverter's QR code. To find it: Open the door on the right-hand side of the top block of your Lunar Battery. After scanning, verify the result matches the SSID on the QR code, then join the network.

  7. Once connected, choose your home Wi-Fi network from the list and enter its password.

When successfully connected, your selected Wi-Fi network will be listed under Connection status with a tick.

Switching to a New Wi-Fi Connection

If you're already connected to Wi-Fi but want to switch to a different network:

  1. Open the app and head to Settings.

  2. Tap Network, then choose Configure Wi-Fi.

  3. Once the list of available Wi-Fi networks loads, select the one you'd like to switch to.

  4. Enter the password for the new network.

  5. Wait a few moments while the connection is established.

Once connected, you'll see your new Wi-Fi network listed under Connection status with a tick. Your previous network will automatically disconnect.

Source document: https://www.lunarenergy.com/support/support-articles/network-connection

Related Articles
Did this answer your question?